Nitek CXM22 4 Channel Crossover Power Insertion and Video Card

• 
  4 Channel Crossover and Power Insertion Card
• 
  Component of the UTPLinks™ System

UTPLinks 4 Channel Crossover, RS422 Distribution & 24 VAC Power Insertion Module - For Use with CX452

The CXM22 crossover insertion cards are designed for use with the CX254 or CX452 modular card cages (sold separately). These units are components of the Nitek UTPLinks video, data & power twisted pair system.

The CXM22 crossover cards are unique unshielded twisted pair (UTP) transmission products designed to operate with TIA/EIA standards-based network cabling. The cards plug into and are powered through the CX254 or CX452 modular card cages. The CX254 and CX452 are 1 RU card cages that holds up to 5 of the crossover insertion cards. The crossover system and power supply are typically located in an IDF (telecom) closet. There are three card models available and any of the three can be plugged into the card cage in any combination. Each card is designed to accommodate 4 cameras.

The primary function of each of the cards is to provide a means of interfacing copper backbone cables to horizontal cable runs and inserting voltage to the individual camera and/or P/T/Z over the horizontal run. In addition, models of the cards are available that provide RS422 distribution and/or video transceivers (see available cards - under Ordering Information). Using a single standards-compliant 4-pair UTP category 5 or better cable, video, data and power can be sent up to 100 meters to a fixed or P/T/Z camera.

Features:

• Three available plug-in cards provide flexibility - any combination of four Crossover cards can be used in any of the CX254 or CX452 card cage slots
• Plug-in cards also provide future system expansion or features modification
• Each of the cards cover 4 zones with separately fused outputs
• One 4-pair category 5 cable can be used for video, RS422 and 24 VAC
• Detection LEDs for power (all cards) and RS422 (CXM22 & CHM22)
• TIA/EIA 568B compatible

Wire and Cable Recommendations

On horizontal runs with fixed cameras (applications up to 8 watts/port) category 5 or better; 22 AWG or 24 AWG. For P/T/Z camera (applications >8 watts/port) category 5 or better; 22 AWG is recommended. In the case of backbone cable 24 AWG Cat 3 or better is recommended. Multi-pair cable with an overall shield is acceptable. While signals may be routed through 66 blocks or 110 blocks, any bridge-taps, also called T-taps and any resistive, capacitive or inductive devices MUST BE removed from the pair.