Nitek PVX44 - 4 Channel Power and Data Inserter Unit

• 
  4 Port Video, Power and Data Distribution Unit
• 
  Component of the UTPLinks™ System

4 Channel Mid Span Power & Data Inserter Unit

4 port passive video, power and data distribution unit. Systems operate with other Nitek UTP video equipment including video hubs, standard video balun transceivers, active transmitters or any twisted pair equipped camera.

The PVX44 utilizes standard 4-pair Category UTP cabling as a means of distributing video, power and data up to 4 cameras. Any third party Class 2 power supplies can be used with the PVX44. VB43ATF video, power, and data transceivers are required at the camera end. The PVX44 transmits 4 video signals from the cameras into one 4-pair Category cable. Nitek M series hubs can be used for quick and secure installations.

The systems can also adapt to existing communication and computer network spare pairs or new cable installations. These units provide superior immunity from noise and interference, even when run in common raceways with AC.

Features:

• High quality video over ordinary twisted pair cable
• Video, power and data over one Category cable
• High immunity to noise and interference
• LEDs to indicate power detection
• RJ45 jacks for quick and secure connections
• Can be used in mid-span, or local network solutions
• Video can be run in the same cable with telephone, computer signals and power
• Compatible with structured wiring installations

Wire and Cable Recommendations

Twisted Sender is recommended for use with unshielded twisted pair (UTP) wiring. The systems will operate over wire gauges from 26 AWG through 12 AWG but are optimized for 24 AWG. Category cabling may be used. Individually shielded pairs should be avoided as they drastically reduce the operating range of the systems. Multipair cable with an overall shield is acceptable. Video can be operated in the same communication cable coexistent with telephone, computer, control signals, power voltages and other video signals. While video may be routed through telephone punchdown block terminals, any bridge-taps, also called T-taps and any resistive, capacitive or inductive devices MUST BE removed from the pair.